Control system for electric discharge machining process

Authors

  • Vladimir Vladimirovich Adamovskiy FGBOU VO «Ufimskiy gosudarstvennyy aviacionnyy tehnicheskiy universitet» (UGATU)
  • Evgeniy Vladimirovich Parfenov FGBOU VO «Ufimskiy gosudarstvennyy aviacionnyy tehnicheskiy universitet» (UGATU)
  • Rustem Halimovich Gancev AO INTC «Iskra»

Keywords:

Electrical discharge machining; die-sinking EDM machine; tool electrode; pulse generator

Abstract

A structure of the EDM process is presented. Major elements of die-sinking EDM machine are analyzed. A block diagram of an automated EDM control system which has three control channels is proposed. The results of developed control system tests in comparison with its previous generation show performance improvement by 10-15%.

Author Biographies

Vladimir Vladimirovich Adamovskiy, FGBOU VO «Ufimskiy gosudarstvennyy aviacionnyy tehnicheskiy universitet» (UGATU)

asp. kaf. teor. osnov elektrotehn. Mag. v obl. inform.-izmerit. tehn. (UGATU, 2015).

Evgeniy Vladimirovich Parfenov, FGBOU VO «Ufimskiy gosudarstvennyy aviacionnyy tehnicheskiy universitet» (UGATU)

prof. kaf. teor. osnov elektrotehn. Dipl. inzh. po prom. elektronike (UGATU,1997). D-r tehn. nauk po avtomat. i upr. tehnol. proc. i proizv. (tam zhe, 2012). Issl. v obl. modelirovaniya, diagnostiki i upravleniya tehnol. processami elektroobrabotki.

Rustem Halimovich Gancev, AO INTC «Iskra»

Direktor AO INTC «Iskra». Dipl. inzh.-elektromeh. (UAI, 1978). Kand. tehn. nauk po elem. avtomatich. ustr. (tam zhe, 1987). Issl. v obl. avtomatiz. tehnol. processov elektroobrabotki.

Downloads

Published

2017-28-04

Issue

Vol. 21 No. 1 (75) (2017): Вестник УГАТУ

Section

MECHANICAL ENGINEERING AND ENGINEERING SCIENCE