The influence of technological cutting conditions on the formation of SRS during the pro-cessing of difficult-to-cut materials

Authors

  • Saiduganov Andrei Radionovich Ufa University of Science and Technology
  • Khadiullin Salavat Khakimovich Ufa University of Science and Technology
  • Chernikov Petr Petrovich Ufa University of Science and Technology
  • Sazanov Andrei Alexandrovich Ufa University of Science and Technology

Keywords:

surface residual stresses, cutting tool, cutting conditions, mathematical modeling, cutting process, finite element analysis

Abstract

This paper presents a study of the influence of cutting tool geometric parameters and cutting modes on the formation of surface residual stress values. These studies were carried out using computer modeling. doi 10.54708/19926502_2025_29210867

Author Biographies

Saiduganov Andrei Radionovich, Ufa University of Science and Technology

Assistant Professor of the Department of Automation of Technological Processes, Ufa University of Science and Technology, 32 Zaki Validi st., Ufa, Republic of Bashkortostan, 450076, Russia

Khadiullin Salavat Khakimovich, Ufa University of Science and Technology

Cand. Sci., Associate Professor of the Department of Automation of Technological Processes, Ufa University of Science and Technology, 32 Zaki Validi st., Ufa, Republic of Bashkortostan, 450076, Russia, 0000-0003-2529-8096, 23670289700

Chernikov Petr Petrovich, Ufa University of Science and Technology

Cand. Sci., Associate Professor of the Department of Automation of Technological Processes, Ufa University of Science and Technology, 32 Zaki Validi st., Ufa, Republic of Bashkortostan, 450076, Russia

Sazanov Andrei Alexandrovich, Ufa University of Science and Technology

Engineer of the Department of Automation of Technological Processes, Ufa University of Science and Technology, 32 Zaki Validi st., Ufa, Republic of Bashkortostan, 450076, Russia

Downloads

Published

2025-23-09

Issue

Vol. 29 No. 2(108) (2025)

Section

******************************