Influence of cutting mode on the formation of residual stresses in EI698-VD turning

Authors

  • Saiduganov Andrei Radionovich Ufa University of Science and Technology
  • Sazanov Andrei Alexandrovich Ufa University of Science and Technology
  • Rustem Anvarovich Ufa University of Science and Technology
  • Chernikov Petr Petrovich Ufa University of Science and Technology
  • Mukhamadeev Vener Rifkatovich Ufa University of Science and Technology

Keywords:

residual stress, turning, cutting mode

Abstract

The study analyzes the effect of cutting modes (speed, feed, constant cutting depth) on the formation of surface residual stresses in the heat-resistant nickel alloy EI698-VD. Key results: The cutting speed (V = 15–55 m/min) determines the depth and nature of the residual stresses. The feed of the cutting tool (S = 0.075–0.2 mm/rpm) affects the type of residual stresses. doi 10.54708/19926502_2026_30211274

Author Biographies

Saiduganov Andrei Radionovich, Ufa University of Science and Technology

Assistant Lecturer of the Department of Automation of Technological Processes

Sazanov Andrei Alexandrovich, Ufa University of Science and Technology

postgraduate student, engineer of the Department of Automation of Technological Processes

Rustem Anvarovich, Ufa University of Science and Technology

Dr. of Tech. Sci. Professor, Professor of the Department of Automation of Technological Processes

Chernikov Petr Petrovich, Ufa University of Science and Technology

Candidate of Technical Sciences, Docent, Associate Professor of the Department of Automation of Technological Processes

Mukhamadeev Vener Rifkatovich, Ufa University of Science and Technology

Senior Lecturer at the Department of Mechanical Engineering Technology

Downloads

Published

2026-07-07

Issue

Vol. 30 No. 2 (2026)

Section

******************************